Hey All,
I have a 2016 Victory CC with a Crossfire conversion. It was squealing and I found that the belt was bad. So I replaced it, as I was replacing it I noticed substantial play in the CV joints and the boots were torn with grease all over the place.
So what I know:
Grease is a pain in the butt to clean
I have tried calling Champion of AZ with no response
i heard the boots were a VW type-1
The joints appear to be non-serviceable, the inner side (attached to the pulley shaft) has a sleeve type expansion joint.
The outer CV (hub sides) is built into a 28 spline spindle
What I don't know:
Can this be locally sourced?
Are there part numbers available?
Is this compatible with any other of the kits?
Is there a better way to contact Champion?
Thanks, Astro
I have a 2016 Victory CC with a Crossfire conversion. It was squealing and I found that the belt was bad. So I replaced it, as I was replacing it I noticed substantial play in the CV joints and the boots were torn with grease all over the place.
So what I know:
Grease is a pain in the butt to clean
I have tried calling Champion of AZ with no response
i heard the boots were a VW type-1
The joints appear to be non-serviceable, the inner side (attached to the pulley shaft) has a sleeve type expansion joint.
The outer CV (hub sides) is built into a 28 spline spindle
What I don't know:
Can this be locally sourced?
Are there part numbers available?
Is this compatible with any other of the kits?
Is there a better way to contact Champion?
Thanks, Astro