Sissy bar mount bolts.

[Foodog2]

Well I lost a sissy bar mount bolt. I guess the previous owner messed those up too. All 4 are drilled out and just the front two have nuts. Today I remove the body to but 4 bolts on.

 

[RKplus10]

Wow, I thought you could get to them by removing the seat. Now I see those rear bolts would be near impossible to reach.
I would like to remove the body on mine one day to level out the rear. How many assistants did you need for the job?

 

[Old Road Dog]

Wow, I thought you could get to them by removing the seat. Now I see those rear bolts would be near impossible to reach.
I would like to remove the body on mine one day to level out the rear. How many assistants did you need for the job?

None. I rigged eye bolts to the rafters and use ratcheting tie down straps (4) to lift the body up then roll the chassis forward. 1 each on the handles and 1 each in the muffler cutouts. Use strips of cardboard and lots of painters tape. Especially in/ on the wrap around louvers around the exhaust. 4 bolts bottom of trunk to frame. 2 forward bulkhead. 1 each side under the sidecovers.if you have a bumper that has to come off. This is also a good time to add slip ons if that's your intent.

 

[Foodog2]

Wow, I thought you could get to them by removing the seat. Now I see those rear bolts would be near impossible to reach.
I would like to remove the body on mine one day to level out the rear. How many assistants did you need for the job?

I think it would have taken me 2 people. I did not remove it, but it’s 8 bolts and pretty straight forward. I was able to get some lumber under the fenders to raise it enough to get a hand in.