Error Message when trying to use the spring pre load

[paid4c4]

[FONT=&quot]When I attempt to add to my spring pre load I get a message "Error." If I wait a few minutes the message goes away and I can access the up and down buttons. The down button allows me to take pressure out but the up button will not put pressure in the system. Any suggestions would be appreciated.[/FONT]

[FONT=&quot]Bill[/FONT]

 

[BrokenBackJack]

There was just a post of this elsewhere on the Trike forum.

They said CSC said to put the selector to 0 and then go in the back and push down or jump on the trailer hitch a few times. After that put your selector to 25 and see if that helps. It did help the other person but don't know about yours.