Recent content by keikat2

  1. K

    Twin-Cooled Lowers' Side Vent Air Flow

    Recently, on my 2014 Tri-Glide, I installed new crash bar highway pegs and mounted them so I would now have three (3) resting positions for my feet: (1). feet fully on floorboards, (2). feet fully on highway pegs, and the newly added (3). heel portion of feet on floorboards w/front feet...
  2. K

    Diagnostic Fault Code Issues

    For the past two (2) weeks, my 2014 Tri-Glide has come down with a "bad case" of Diagnostic Fault Codes. Initially, the DTC codes were identified as U0001 (Can Bus Error), U0002 (Can Bus Perf Error), U0142 (Lost Comm w/RHCM) in each of the ECM, BCM, SPDO, and RAD monitoring areas. Also, Code...
  3. K

    "C" CLAMP USE

    On my 2014 Tri-Glide, I am having a difficult time getting the left rear wheel caliper piston to recess and seat inside its caliper housing. As mentioned to me in an earlier inquiry, I do not see two (2) holes or indentions in the piston's front facing surface area, so I don't think the piston...
  4. K

    REAR ROTOR BOLTS REMOVAL

    I am presently in the process of replacing my brake pads and rear rotors on my 2014 Harley Tri-Glide. Seems to me, I remember reading or being advised about the possibility of "reverse threaded" bolts. However, I do not see any mention of "reverse threaded" bolts in the Trike Supplement Service...
  5. K

    Harley Dealership Mail Order Restriction

    I was getting ready to order some Tri-Glide parts from the Surdyke Harley dealership website. However, I had some questions concerning the parts; and, in turn, sent an email to their customer service email address. Almost immediately, I received an email response back indicating Harley has now...
  6. K

    2014 HD Tri-Glide Rear Brake Rotor/Brake Pad Replacement Video

    2014 HD Tri-Glide Rear Brake Rotor/Brake Pad Replacement Video I am going to replace the rear brake pads on my 2014 Tri-Glide and am thinking about replacing the rear rotors, as well, since the left rear rotor has a small circular groove cut into the rotor. In turn, is anybody aware of an...
  7. K

    Harley Fuel Filter

    Is there any reason why I should use a Harley OEM Fuel Filter for replacement on my 2014 Tri-Glide? Even though aftermarket fuel filters appear to be same design and manufactured paper material, is there something special about the Harley OEM fuel filter I should be aware of? Thank you...
  8. K

    2014 HD Tri-Glide Rear Rotors

    For those who have replaced their Trike's rear rotors, did you purchase/install cast iron or steel rotors? Also, what type of brake pads did you purchase/install, as well. Thank you, in advance, for your comments and suggestions. Allen S.
  9. K

    Rockford Fosgate TM400X4AD 400W Amplifier Concern

    First of all, I would like to give a special shout out and say "THANK YOU" to Papa Zook for helping me reset my Trike Talk website password. For some reason, when requesting a "forgotten password reset", I am unable to receive the website's forwarding email to reset my password. Once again...
  10. K

    Are tires to old???

    I have a Michelin Commander II MTB90-16 front tire (not rear tire) installed on my 2014 Tri-Glide front wheel. The tire still appears to have plenty of tread depth remaining and overall looks to be in excellent condition. Preparing for an end of month Texas to East Coast trip, I was...
  11. K

    Extended Brake Pedal Issue

    About two months ago, I removed my 2014 Tri-Glide's OEM rear brake pedal and installed a Kuryakyn Extended Brake Pedal. After finally getting the new brake pedal installed, I certainly like the flatter foot to pedal position when applying the rear brakes. It feels more natural than the...
  12. K

    2014 Tri Glide Infotainment Radio Equalizer Flash

    Hi, I have installed on my 2014 Tri Glide a 200W Hogtunes 4 channel amp w/J&M Rokker 6.65" XXR front/rear speakers. I would like to have my Harley Infotainment Radio's equalizer preset curve viewed and reset to a flatter setting if necessary. Does anybody know a motorcycle audio dealer in the...
  13. K

    Rocker Lockers Install vs. Cylinder Position

    Hi, I am thinking about installing a set of Rocker Lockers to reduce the "ticking sound" created by the cylinder head's support plate bolts. To install the Rocker Lockers, I notice the instructions indicate "the cam must be on the base circle so that neither valve is open or under pressure"...
  14. K

    Turn Signals vs. Speakers Issue

    Has anybody ever had issues with the sound of the turn signals coming thru their infotainment speakers? This has been going on a while. However, at highway speeds, it's not heard due to the increased wind noise. Thank goodness, the blinker sound does not increase as the infotainment volume...
  15. K

    LJ Mighty Mite Fans Connected To Left Side ACC Power Plug

    I have a question. In turn, if my question sounds unrealistic or not applicable, please forgive my asking. With having the LJ Mighty Mite fans connected to the left side ACC power plug, does anyone see any issue(s) with the + or - 12V power going directly to the fans while the Trike is in the...

Welcome to the Trike Talk Community

Join our vibrant online community dedicated to all things Trikes! Whether you're a seasoned rider or just starting out, this is the place to share experiences, tips, and stories about your three-wheeled adventures. Explore modifications, maintenance advice, and rides, all while connecting with fellow trike enthusiasts from around the globe

Register Log in

Forum statistics

Threads
55,466
Messages
805,810
Members
24,012
Latest member
Boatpaddle
Register Log in

Share this page

155 wide Papa Zook’s Harley Rake Kits

photo 260e2760-d89e-45b2-8675-2bc26fb3d465.jpg

photo Trike-Talk-150-x-200.gif

photo DK Trike Talk Right side banner 19.jpg

photo 9796095c-0d4b-4a9b-88ed-efe4c498d084.png
photo f9866e4e-75c5-471a-86f5-5e72a446ecc3.png
Back
Top Bottom