2018 Tri Glide. After hitting the Vehicle Information switch the Vehicle Status screen shows a line for "oil pressure". Mine is showing "check oil". The oil level is correct (checked hot) and only a few hundred miles since the last dealer oil change. Any suggestions?
Vehicle Information Switch
- Thread starter jeeptrix
- Start date
It’s just A reminder….like my clothes dryer a light flashes check filter before I press the start button..
Start the bike - then go to the info screen and take a look.
Koolbreeze
100+ Posts
^^^^^^This^^^^^^^ without the engine running you will get the check oil message.
- Thread starter
- #5
Planning a breakfast ride tomorrow and if it is not raining I will check it out. Thanks for the tip.
- Thread starter
- #6
I had a 2018 TG as did a friend. During a road trip his bike did the same thing and his oil was full. Rode on with no problem. A few months later mine also did the same thing. New oil pressure switch fixed the problem on them both.
Glad it worked - thanks for the update
My 2017 TG failed to show oil pressure OK on the dash idiot light a few times over the past few years. Shutting it down and restarting always corrects it. Never heard any engine noises when this happened. Suspect that an oil pressure switch replacement would make this go away, but it has been very sporadic and limited (only 3 or 4 times in a couple years). Guess I would rather see it not indicate oil pressure when there was, than indicate pressure when there wasn't.
Similar threads
Welcome to the Trike Talk Community
Join our vibrant online community dedicated to all things Trikes! Whether you're a seasoned rider or just starting out, this is the place to share experiences, tips, and stories about your three-wheeled adventures. Explore modifications, maintenance advice, and rides, all while connecting with fellow trike enthusiasts from around the globe
Forum statistics
Share this page
