Need some advice on installing Honda CB module.

[Will]

Bought a pre-owned Honda CB module to install in my just-aquired 06 G/W trike. The module has a long cord with connector, that I realize must be plugged into the back of the audion control center, so that will require removing or loosening the upper fairing. OK.

Then there is a short cable with a 3 pin (I think) connecter, for power and ground. What I'd like to know, is where is that mating connector, and since I don't have a CD player, if I mount the CB module where the player would normally go (in the trunk), will the power cable reach?

Any other advice to offer for this project?

 

[kj5ix]

Down load this:

http://www.gwrra-oks.org/install/GL1800 oem cbinstall.pdf

You can side step some of the steps shown if you are familiar with the 1800.

 

[Will]

Thanks George. I printed that installation guide, and will have it as a reference, for routing the wiring, etc. during install.

73,
Will (K3RBP)

 

[Maverick]

You don't have to remove the trunk in order to install the CB.