Hello everyone, I have asked Randy to remove the Snowbird post for a few reasons. Because of this crazy virus that seems to be never ending we have had to cancel the last 2 get togethers and it doesn't look like it's going to end in the near future.
Because of my back injury and probable...
The silver cylinder with the yellow tag has the plug in the bottom, just put a flat blade screw driver under the rubber and pop it down and out. Allen wrench maybe a 5 or 6 mm or sae I don't remember. Hope this helps. Tom
Hello to all that have attended our get together over the past years but I have to say that because of the on going virus issues I will not be setting anything up this year. There are several of our usual group that have either bought homes in the area or renting from 1-6 months pretty much...
Trailer hitch and lugged rack mods
Shortened both ends of the rack by one section and my wheeled trunk fits great. Shortened the reciever tube about 1 1/2" and angle cut it to have more weld on the tube. I can still use the reciever for a ball mount if needed, just have to angle cut...
Ok everyone, date is 15-19 March 2020 at the Castillo Del Sol Best Western Ormond Beach, Florida 32176, 205 S Alantic Ave. Phone 386-672-6711. Rates are $84.15+tax which was about $95 total for ocean view. If you want the ocean front that will be extra. If the motel is not booked solid...
The wait is over and it was delivered last Thursday nite. The vehicle is so new the insurance company didn't have any info on it so they had to have the underwriters get the vehicle added to their system which took until Monday late. Tomg
It's not the seal, it's the outer edge of the axle. It needs to be slightly beveled on the outer edge so it slides thru the seal. Grease the axle before putting it in. This works, I know! Tomg
For me, 1 dim headlight for daytime light operations , turn light switch for low beam and option to pull knob out for both side driving lights. Push turn signal lever to get high beam which shuts off driving. 1 light for low beam, 2 lights for high beam. Photo from owmers manual . Tomg
part number, bearings removed and outer park of bearing that had to be beat out! Only have a small slot from the inside to be able to drive it out. You have almost the complete outside race of the bearing to press out if you remove the tubes. Hope this helps. I'll dig up the part numbers for...
Join our vibrant online community dedicated to all things Trikes! Whether you're a seasoned rider or just starting out, this is the place to share experiences, tips, and stories about your three-wheeled adventures. Explore modifications, maintenance advice, and rides, all while connecting with fellow trike enthusiasts from around the globe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.